Printer-friendly version

Simplified multi-color knitting with color charts. Stitch sequences numbered. Each row knitted across and purled back in the same colors.

Sizes 10 to 13.

IMPORTANT

Knit across and purl back each row before starting next row. Use size NUMBER ONE needles. Knitting tension should be tight enough to produce about 10 stitches per inch. If you do not obtain this gauge, then change to larger or smaller needles as your particular knitting tension requires. The size needle does not matter as long as the stitch gauge attained is correct. Note: 10 stitches per inch means 'as knit', without allowance for blocking. Socks then block to about 9 stitches per inch on usual size dryers, and will cling snugly to the average size leg when worn. For a very small size leg (such as 7 inches around above ankle) you may wish to knit to a tighter tension gauge than mentioned above, using the smallest possible needles. Use your own choice of yarn colors.

NOTE: ROWS NOS. 22, 24, 27, & 29 HAVE STITCHES WHICH ARE PURLED BACK IN A DIFFERENT COLOR TO FORM FINER DETAIL IN THE DESIGN OF THE GOLF BALL. THESE STITCHES ARE INDICATED BY THE SQUARES WHICH ARE DIVIDED IN HALF AND COLORED ACCORDINGLY. SEE FULL DIRECTIONS BELOW.

NOTE (CHOOSING YARN)

In choosing yarn, be sure colors selected are in good contrast to show the design in sharp detail.

DIRECTIONS

(It is preferable that the knitter be familiar with basic knitting instructions pertaining to plain socks. However, directions herein are complete, including recommended methods for heel and toe which place sewed seams at side of foot to insure wearing comfort. Free detailed instructions on how to knit, purl, etc., should be obtainable from your yarn shop.)

MATERIALS—(Note: Different brands of yarn vary in yardage. The following yarn quantities for an average size pair of socks, are approximate only. 1 oz. blue, 1 oz. green, 4 yds. ea. brown and white. Socks illustrated are 7 inches long above top of heel, including 2 inches of ribbing. If longer socks are desired, add ribbing or plain rows at top. Use size No. One sock needles, double pointed, and regular 3-ply sock yarn.

IMPORTANT—Use needles and yarn in these accurate sizes in order to achieve proper size sock per this pattern. Knitting tension should produce an average gauge of about 10 stitches per inch. Note: It is well to carry your yarn in small quantities of each color, on bobbins which dangle clear of your work, avoiding entanglement. For the small color groups in this pattern it as possible to dispense with bobbins and use short 20-inch strands of yarn simply dangling free. This applies to the stitches representing the golf clubs, flags, etc. The background color can be knit from a single bobbin where only the single stitches in the clubs and flag interrupt. Simply carry the blue yarn across the interrupting brown stitches (on wrong side of work). Where more than 2 stitches interrupt the background color, as in the white flags and golf ball, it is best to use separate bobbins on each side unless the knitter is familiar with the proper method of twisting the yarn carried with the yarn being worked—which is necessary to prevent an undesirable loop of yarn on inside of sock. Thus 3 bobbins of blue will be necessary, also 2 bobbins of green, plus short strands for small in-between areas.

LEG PATTERN—This part of sock is knitted in a flat piece, eventually to be folded and sewed together up the back. First cast on 72 stitches of basic color and knit 2, purl 2 for ribbing for 2 inches. In starting first pattern row, knit first 2 stitches together to decrease to 71 stitches. Then knit first row as shown in graph, that is, 30 blue, 1 brown, 9 blue, 1 brown … etc., to end of row. These numbers are indicated on graph to save counting squares. In changing colors always twist yarns around each other once to avoid leaving a hole. Now turn and purl back ON THIS SAME ROW using the same colors in the same places. Now knit row 2 in the indicated color sequence, 31 blue, 1 brown … etc., and purl back as before. Continue knitting the successive rows in this manner using the color sequences indicated on the graph. After row No. 36 the work separates to knit the heel. Divide the 71 stitches, taking 18 off each end and place on a separate needle for the heel. In so doing the leg of the sock is folded into position for sewing up the back later. Leave the 35 center stitches on one needle and discontinue work thereon while doing the heel.

HEEL (Reinforced type)—Using the 36 stitches on the heel needle, slip 1, knit 1, in sequence for the first row, then purl back. Continue thus in successive rows, for 2 inches. On the last purl row, purl 20 stitches, then purl 2 together, purl 1 and turn work.
Then:
Knit back 6, knit 2 together, knit 1, turn.
Purl back 7, purl 2 together, purl 1, turn.
Knit back 8, knit 2 together, knit 1, turn.
Purl back 9, … etc.
Knit back 10, … etc.
… Etc.
Continue in this manner, advancing the number of stitches worked at each end in this order, and thus making rounded bottom of heel until all stitches are used, work then being all on one needle across bottom of heel. Now pick up stitches along the forward edges of the heel thus knitted, and add to the work in progress. About 21 or 22 stitches should be picked up on each side of the 2-inch long heel, and all of these heel stitches should be evenly divided on 2 needles.

INSTEP—At this point the entire sock is on three needles, consisting of the instep needle with the 35 center pattern stitches (which must be kept separate), and the two underfoot needles on which the stitches along the edge of the finished heel are evenly divided. Now use a 4th working needle and knit the plain color foot round and round as with plain socks, and at the same time form the triangular gusset which widens the ankle, by decreasing 1 stitch at the forward point of each underfoot needle ON EVERY OTHER ROW until only 18 stitches remain on each underfoot needle. You will probably decrease 13 or 14 times depending on whether 21 or 22 stitches were picked up along the heel edge. Continue knitting the foot without further decreasing until 2½ inches from the desired length of the foot.

TOE—Now start decreasing to shape toe, as follows: Decrease 4 stitches on the next row, these being the end stitches on the instep needle, and the stitches next to these, one on each under-foot needle. Knit 4 rows plain then 1 row decreasing 4 stitches as before, 3 rows plain, 1 decreasing, 3 plain, 1 dec., 2 plain, 1 dec., 2 plain, 1 dec., 1 plain, 1 dec., then decrease every row until only 15 stitches remain (7 on instep needle and 4 on each underfoot needle.) Weave toe as follows: Place yarn in a tapestry needle and, with yarn coming from back of knitting needle, put it in first stitch of front (instep) needle as if to knit and slip it off. Then put it in the next stitch of front needle as if to purl and leave it on. Go to back (underfoot) needle and insert as if to purl and take it off, then to next stitch of back needle as if to knit and leave it on. This designation may assist:
Front needle K—off P—on
Back needle P—off K—on
Repeat thus to the end of the 8 stitches on each needle.

FINISH—Sew sock up the back, using corresponding color of yarn and tapestry needle. Finish inside of sock by weaving any thread ends info nearby seams, trimming ends, etc. Block socks on dryers of proper size.

GENERAL DIRECTIONS

Each square equals one stitch, knitted and/or purled. Sequences of stitches in particular colors to form a pattern are shown in color and by numbers on the specific pattern graphs. This saves counting squares. The number of rows and number of stitches in each, depend on the symmetry of the pattern design, also on the approximate size of sock desired in order to fit the wearer's leg. Size and dimensions are indicated in each particular pattern.

Each row is normally knitted and purled back in the same colors. For certain patterns which are easily repeated, the knitter may, in purling back, go to the next row. In this case the indicated pattern will be reduced in size by one-half, and the entire pattern must then be repeated in order to achieve the length indicated.

Heel, bottom of foot, and toe are knitted in the manner of plain socks. In certain patterns where the instep is a plain color, and the same color as the foot, this part of the sock may be knitted round and round as in plain socks.